Applied-motion TXM24C-1CG Bedienungsanleitung PDF herunterladen (Seite 2)

▪Download and install Step-Servo Quick Tuner software, available at www.applied-motion.com.

▪Launch the software by clicking Start/Programs/Applied Motion Products/Step-Servo Quick Tuner

▪If you have any questions or comments, please call Applied Motion Products

Customer Support 800-525-1609 or visit us online www.applied-motion.com.

If you have any questions or comments, please call Applied Motion Products Customer Support:

(800) 525-1609, or visit us online at www.applied-motion.com.

404 Westridge Dr.

Watsonville, CA 95076, USA

1-800-525-1609

Tel (831) 761-6555

Fax (831) 761-6544

www.applied-motion.com

TXM24C Quick Setup Guide

920-0093 Rev. A

Step2 - Step-Servo Quick Tuner

Step3 - Configuration

a) Apply power to the drive.

b) UsetheStep-ServoQuickTunertosetupthemotorcurrent,limitswitches,I/O,tuningandQprogram.

c) Set BitRate, Node ID

CANopen Bitrate - AMP CANopen drives have two set tings, one for Bit Rate and another for Node ID. The Bit Rate

isconguredusingStep-ServoQuickTuner.

TheNodeIDisconguredusingStep-ServoQuickTuneralso.ValidrangesfortheNodeIDare0x01through0x7F.

NodeID0x00isreservedinaccordancetoDS301specication.

Note: The Node ID and Bit Rate is captured only after a power cycle, or after a network reset command has been

sent.ChangingtheswitcheswhilethedriveispoweredonwillNOTchangetheNodeIDandBitRateuntiloneof

these conditions has also been met.

d) The Step-Servo Quick Tuner includes a self test option (under the Drive menu) to verify that the TXM24C and

powersupplyarecorrectlywiredandcongured.

e) Whencongurationiscomplete,exittheStep-ServoQuickTunerthedrivewillautomaticallyswitchtoCANopen

Mode.

1 2

Keine Kommentare

Applied-motion TXM24C-1CG Bedienungsanleitung Seite 2