Applied-motion TSM17Q-1AG Bedienungsanleitung PDF herunterladen (Seite 6)

Rev. A

920-0084

TSM17S/Q Hardware Manual

2 Getting Started

The following items are needed:

• a 12 - 48 Volt DC power supply, see the section below entitled “Choosing a Power Supply” for

help in choosing the right one

• a small at blade screwdriver for tightening the connectors (included)

• a PC running Microsoft Windows XP, Vista, or Windows 7 or 8

• an Applied Motion Products programming cable (included with RS-232 Models; RS-485

converters are available from Applied Motion Products)

2.1 Installing Software

Before utilizing the TSM17S/Q Integrated Step-Servo Motor and Step-Servo Quick Tuner Software

in an application, the following steps are necessary:

• Install the Step-Servo Quick Tuner software from the Applied Motion Products website.

• Connect the drive to the PC using the programming cable. When using RS-485, it must be

setup in a 4-Wire conguration (see “Connecting to a host using RS-485” below.)

• Connect the drive to the power supply. See instructions below.

• Launch the software by clicking Start...Programs...Applied Motion Products.

• Apply power to the drive.

• The software will recognize the drive and display the model and rmware version. At this point,

it is ready for use.

2.2 Mounting the Hardware

As with any step motor, the TSM17S/Q must be mounted so as to provide maximum heat sinking

and airow. Keep enough space around the Integrated Motor to allow for airow.

• Never use the drive where there is no airow or where other devices cause the

surrounding air to be more than 40°C (104°F).

• Never put the drive where it can get wet.

• Never use the drive where metal or other electrically conductive particles can

inltrate the drive.

• Always provide airow around the drive.

1 2 3 4 5 6 7 8 9 10 11 ... 28 29

Keine Kommentare

Applied-motion TSM17Q-1AG Bedienungsanleitung Seite 6